VAR-SOM-AM43 Start Here Fido: Difference between revisions
(Created page with "{{PageHeader|VAR-SOM-AM43 - First Time? Start Here.}} {{DocImage|category1=VAR-SOM-AM43|category2=Yocto}} __toc__ x300px = Step One: Read Documentations = P...") |
m (Text replacement - "http://variscite" to "https://variscite") |
||
Line 27: | Line 27: | ||
* Use your pre-built rescue recovery SD-Card, as-is, to boot system, and start applications programming. email support@variscite.com for FTP credentials. | * Use your pre-built rescue recovery SD-Card, as-is, to boot system, and start applications programming. email support@variscite.com for FTP credentials. | ||
**[ | **[https://variscite.com/support-forum/viewtopic.php?f=9&t=27 Compiling QT5 application] | ||
**[[VAR-SOM-AM33 Linux SDK 7 Basic debug with Eclipse| Application debugging with Eclipse]] | **[[VAR-SOM-AM33 Linux SDK 7 Basic debug with Eclipse| Application debugging with Eclipse]] | ||
Line 34: | Line 34: | ||
* Contact Support | * Contact Support | ||
** [ | ** [https://variscite.com/support-forum/index.php Support forum] | ||
** support@variscite.com | ** support@variscite.com |
Revision as of 11:56, 10 June 2020
Step One: Read Documentations
Please download and read the development kit documentation. on Variscite website:
http://www.variscite.com/products/system-on-module-som/cortex-a9/var-som-am43-cpu-ti-am437x-am4376-am4377-am4378-am4379
Make sure you read the Quick Start Guide.
Step Two: Setup Linux host PC Development Environment
Set up your development environment.
Step Three: DVK Power Up
Power up the board.
You should have the serial cable connected to the debug port, as describe in the quick start guide
When board boots, make sure you see the u-boot prints on your host PC hyper terminal. You will need to type-in commands in the command prompt late in the development stages
Don't continue without the serial console operating.
Step Four: A quick test with NAND recovery SD-Card
Please follow the below guide to boot DVK with a bootable SD-Card , and burn a complete yocto into NAND-Flash
Step Five: What next?
Your next step can be one of :
- Build a complete Yocto. This guide will help you build a complete Yocto build, resulting in all required binaries to create a full bootable Yocto SD-Card, and all required binaries to burn to NAND-Flash.
- Use your pre-built rescue recovery SD-Card, as-is, to boot system, and start applications programming. email support@variscite.com for FTP credentials.
- Test various interfaces : go to 'How to' section in main page.
- Contact Support
- Support forum
- support@variscite.com