Difference between revisions of "Yocto Build U-Boot"

From Variscite Wiki
Line 52: Line 52:
  
 
Obtain SC firmware:<br>
 
Obtain SC firmware:<br>
Either build it by following the {{Varlink|Yocto_Build_SCFW|{{#var:RELEASE_LINK}}|Build SCFW from source code}} page, or just download the pre-built binary by running:
+
{{#ifexpr: {{#var:YOCTO_VERSION}} < 3.1 |Either build|Build}} SCFW by following the {{Varlink|Yocto_Build_SCFW|{{#var:RELEASE_LINK}}|Build SCFW from source code}} page{{#ifexpr: {{#var:YOCTO_VERSION}} < 3.1 |, or download the pre-built binary by running:<br>
  $ wget {{#var:META_VARISCITE_GIT}}/raw/{{#var:META_VARISCITE_BRANCH}}/recipes-bsp/imx-sc-firmware/imx-sc-firmware/{{#var:SC_FIRMWARE}} -O scfw_tcm.bin
+
  $ wget {{#var:META_VARISCITE_GIT}}/raw/{{#var:META_VARISCITE_BRANCH}}/recipes-bsp/imx-sc-firmware/imx-sc-firmware/{{#var:SC_FIRMWARE}} -O scfw_tcm.bin|
 +
.<br><br>}}
  
 
Download SECO firmware:
 
Download SECO firmware:

Revision as of 18:34, 25 April 2021

Yocto Build U-Boot from source code

1 Toolchain installation for out of Yocto builds

To install the toolchain, follow Yocto Toolchain installation.

2 Build U-Boot out of Yocto tree

Obtain sources:

$ git clone https://github.com/varigit/uboot-imx.git -b imx_v2015.04_4.1.15_1.1.0_ga_var03
$ cd uboot-imx

Configure compilation environment:

$ source /opt/fslc-x11/2.2.1/environment-setup-armv7at2hf-neon-fslc-linux-gnueabi

Cleanup everything:

$ make mrproper

Select one of the following configurations:

For booting from SD card/eMMC:
$ make mx6var_som_sd_defconfig

For booting from NAND flash:
$ make mx6var_som_nand_defconfig

Build U-Boot:

$ make -j4


3 Install the built U-Boot on an SD card


$ sudo dd if=SPL of=/dev/sdX bs=1K seek=1; sync
$ sudo dd if=u-boot.img of=/dev/sdX bs=1K seek=69; sync
(Replace /dev/sdX with the correct device)

If you want to use our recovery SD card to flash the built U-Boot to NAND flash/eMMC, then copy it to the appropriate location in the SD card:

$ sudo cp SPL /media/rootfs/opt/images/... 
$ sudo cp u-boot.img /media/rootfs/opt/images/...

And eject the SD card gracefully from host machine.


Note: If you manually upgrade an existing U-Boot, and you have an old environment saved, it is a good idea to reset your environment to the new default (see Environment handling commands)

4 Update your U-Boot out of Yocto tree

$ git pull