Difference between revisions of "Yocto Build U-Boot"

From Variscite Wiki
(imx8mq fix default dtb)
Line 1: Line 1:
 
<!-- Set release according to "release" parameter in URL and use RELEASE_MORTY_V1.0_VAR-SOM-MX6 as default
 
<!-- Set release according to "release" parameter in URL and use RELEASE_MORTY_V1.0_VAR-SOM-MX6 as default
--> {{#vardefine:RELEASE_PARAM|{{#urlget:release}}}} <!--
+
--> {{#vardefine:RELEASE_PARAM|{{#urlget:release|RELEASE_MORTY_V1.0_VAR-SOM-MX6}}}} <!--
--> {{#lst:Yocto_Platform_Customization|{{#var:RELEASE_PARAM|RELEASE_MORTY_V1.0_VAR-SOM-MX6}}}} <!--
+
--> {{#lst:Yocto_Platform_Customization|{{#var:RELEASE_PARAM}}}} <!--
 +
--> {{#lst:B2QT_Platform_Customization|{{#var:RELEASE_PARAM}}}} <!--
 
--> {{PageHeader|Yocto Build U-Boot from source code}} {{DocImage|category1=Yocto|category2={{#var:HARDWARE_NAME}}}} __toc__
 
--> {{PageHeader|Yocto Build U-Boot from source code}} {{DocImage|category1=Yocto|category2={{#var:HARDWARE_NAME}}}} __toc__
 
= Toolchain installation for out of Yocto builds =
 
= Toolchain installation for out of Yocto builds =

Revision as of 16:54, 1 March 2021

Yocto Build U-Boot from source code

1 Toolchain installation for out of Yocto builds

To install the toolchain, follow Yocto Toolchain installation.

2 Build U-Boot out of Yocto tree

Obtain sources:

$ git clone https://github.com/varigit/uboot-imx.git -b imx_v2015.04_4.1.15_1.1.0_ga_var03
$ cd uboot-imx

Configure compilation environment:

$ source /opt/fslc-x11/2.2.1/environment-setup-armv7at2hf-neon-fslc-linux-gnueabi

Cleanup everything:

$ make mrproper

Select one of the following configurations:

For booting from SD card/eMMC:
$ make mx6var_som_sd_defconfig

For booting from NAND flash:
$ make mx6var_som_nand_defconfig

Build U-Boot:

$ make -j4


3 Install the built U-Boot on an SD card


$ sudo dd if=SPL of=/dev/sdX bs=1K seek=1; sync
$ sudo dd if=u-boot.img of=/dev/sdX bs=1K seek=69; sync
(Replace /dev/sdX with the correct device)

If you want to use our recovery SD card to flash the built U-Boot to NAND flash/eMMC, then copy it to the appropriate location in the SD card:

$ sudo cp SPL /media/rootfs/opt/images/... 
$ sudo cp u-boot.img /media/rootfs/opt/images/...

And eject the SD card gracefully from host machine.


Note: If you manually upgrade an existing U-Boot, and you have an old environment saved, it is a good idea to reset your environment to the new default (see Environment handling commands)

4 Update your U-Boot out of Yocto tree

$ git pull