Debian AM62 Flash From Net

Warning: This page is designed to be used with a 'release' URL parameter.

This page is using the default release am62-debian-bookworm-6.1.83_09.02.01.10-v1.0.
To view this page for a specific Variscite SoM and software release, please follow these steps:

1. Visit variwiki.com
2. Select your SoM
3. Select the software release

VAR-SOM-AM62 - Flash Debian images from network

Flashing a complete Debian system from Network using TFTP & NFS

NOTES:

1. Please make sure your host system is ready to use TFTP/NFS. Use our Wiki if required: Debian Setup TFTP/NFS
2. This is a concept Wiki. Please adapt it to your system and your requirements.

Build minimal file system

To setup a build environment follow steps to Build the Debian image guide.

And build the image:

$ cd ~/debian_am62x_var_som/ti-bdebstrap
$ sudo ./build.sh am62-bookworm-09.02.01.10_var01

Create a root file system and copy files:

$ mkdir ~/flash_rootfs
$ sudo tar -xvf ~/debian_am62x_var_som/ti-bdebstrap/build/am62-bookworm-09.02.01.10_var01/tisdk-am62-bookworm-variscite-am62x-var-som-rootfs.tar.gz -C ~/flash_rootfs
$ sudo cp -a ~/flash_rootfs/boot/*.dtb /tftpboot
$ sudo cp ~/flash_rootfs/boot/Image /tftpboot

Edit /etc/exports. E.g.

$ sudo gedit /etc/exports

...and add the following line to it (replace <uname> with the actual username):

/home/<uname>/flash_rootfs    *(rw,sync,no_root_squash,no_all_squash,no_subtree_check) 

Restart the NFS server:

$ sudo /etc/init.d/nfs-kernel-server restart

Insert the recovery SD card into your host PC and copy the following files from it (assuming it is mounted at /media):

$ sudo cp -a /media/rootfs/opt/images ~/flash_rootfs/opt/
$ sudo cp /media/rootfs/usr/bin/*.sh  ~/flash_rootfs/usr/bin/

Boot the board, stop the autoboot to get to the U-Boot command line, and set the following environment variables:

=> setenv serverip <your host ip address>
=> setenv nfsroot /home/<your username>/flash_rootfs

If you want to set the fdt file yourself, instead of using the default auto detection:
=> setenv fdt_file <relevant device tree>

=> setenv bootcmd 'run netboot'
=> saveenv
=> boot

On the target flash your system:

# install_debian.sh

A complete system is flashed into the SOMs internal storage (NAND flash/eMMC).
Once the file system is built you can use it again and again to flash your VAR-SOM-AM62.
You can update the images to use your images and/or customize install_debian.sh to your requirements.