Setting ADB over Wi-Fi

Run the following steps to enable the ADB over Wi-Fi.

Connect micro USB cable to J20 of the VAR-SD410CustomBoard and boot the device.
You should see adb enumerated on “Device Manager” once the device boots into Android.
Run the following commands at the command prompt:

adb wait-for-device && adb root && adb wait-for-device && adb remount && adb wait-for-device
adb shell "echo service.adb.tcp.port=5555 >> /data/local.prop"
adb shell chmod 0644 /data/local.prop

Disconnect micro USB cable from J20 connector to allow USB Host operation.
Select following options on the SD410CustomBoard:
- settings -> Wi-Fi -> On, Select a network and, if necessary, enter the password
- settings -> display -> Sleep -> 30 minutes
- settings -> Security -> Screen Lock None
- settings -> About phone -> Build Number x8 (press build number eight times to enable developer mode)
- settings -> Developer Options -> Stay Awake
- settings -> Developer Options -> Verify Apps over USB -> OFF
- Settings -> WIFI -> Long press on the Connected Network -> Modify Network
- Remember the IP address that displayed on the Modify Network screen.
Connect to ADB over Wi-Fi (command prompt):

ping <ip address>
adb connect <ip address>:5555
adb devices

At this point you no longer need the USB cable to load programs.
Root access to the SD410CustomBoard (after completing the above steps to set up everything)

adb shell su

DART-SD410 Android Setting ADB over Wi-Fi

Setting ADB over Wi-Fi