Template:Yocto Toolchain installation IMX

Yocto toolchain installation for out of Yocto builds

Prerequisites

A full Yocto build environment is required for the toolchain generation.
To setup a Yocto build environment follow steps 1 & 3 of the Build Yocto from source code guide and then proceed to either the toolchain or complete SDK steps below:

Build a toolchain

Setup the environment:

 Expression error: Unexpected > operator. Expression error: Unexpected >= operator. Expression error: Unexpected >= operator.  
$ cd 
$ MACHINE= DISTRO=

Build the toolchain:

$  bitbake meta-toolchain

Build a complete SDK

To compile applications that require libraries other than glibc you should build an SDK which contains development versions of all libraries in the rootfs image, and not just the basic toolchain.

 Expression error: Unexpected > operator. Expression error: Unexpected >= operator. Expression error: Unexpected >= operator.  
$ cd 
$ MACHINE= DISTRO=

E.g. when using the fsl-image-gui image:

$  bitbake -c populate_sdk fsl-image-gui

The SDK should match the rootfs image on the target, otherwise you may experience difficulties when trying to debug application failures.

Install the toolchain/SDK

Install the tools by running the resulted script in tmp/deploy/sdk/.

E.g.

$ tmp/deploy/sdk/

Note: The toolchain/script name depends on your build machine and the bitbaked image/recipe, and may change.

Accept all the default options, and at the end of the installation you should see the following:

SDK has been successfully set up and is ready to be used.

Use the toolchain/SDK

Each time you wish to use the toolchain in a new shell session, you need to source the environment setup script:

$ source