Debian Setup TFTP/NFS
This page is using the default release RELEASE_BUSTER_V1.0_DART-MX8M-MINI.
To view this page for a specific Variscite SoM and software release, please follow these steps:
- Visit variwiki.com
- Select your SoM
- Select the software release
Running Debian rootfs on Variscite board using TFTP & NFS
On the Host
Make sure you installed NFS server:
$ sudo apt-get install nfs-kernel-server $ cd ~/var_mx8mm_dart_debian_buster $ mkdir -p ~/rootfs_debian_nfs $ cd ~/rootfs_debian_nfs $ sudo tar xvf ~/var_mx8mm_dart_debian_buster/output/rootfs.tar.gz -C .
$ sudo gedit /etc/exports
Add the following line (change <uname> to the name of user):
/home/<uname>/rootfs_debian_nfs *(rw,sync,no_root_squash,no_all_squash,no_subtree_check)
exit & save
$ sudo /etc/init.d/nfs-kernel-server restart
Make sure you installed TFTP server:
$ sudo apt-get install xinetd tftpd tftp
Verify the following:
$ ls /usr/sbin/in.tftpd $ sudo gedit /etc/xinetd.d/tftp service tftp { protocol = udp port = 69 socket_type = dgram wait = yes user = nobody server = /usr/sbin/in.tftpd server_args = /tftpboot disable = no }
and run:
$ sudo mkdir /tftpboot $ sudo chmod -R 777 /tftpboot $ sudo /etc/init.d/xinetd restart $ cd ~/var_mx8mm_dart_debian_buster
$ sudo cp -a output/*.dtb /tftpboot $ sudo cp -a output/Image.gz /tftpboot
Follow our kernel compilation guide Build kernel from source code
Run "make menuconfig", go to "Device Drivers → Network device support → Ethernet driver support → Freescale devices → FEC ethernet controller" and press y.
On the Target
Make sure you have a serial connection to the target.
Reset and hold the space bar. This will bring you to U-Boot command line.
=> setenv serverip 192.168.1.188 (change 192.168.1.188 to server IP based on your network configuration) => setenv nfsroot /home/<uname>/rootfs_debian_nfs (change <uname> to the name of user) => setenv bootcmd run netboot => saveenv
You are all set. Connect Ethernet cable, power cycle the DART-MX8M-MINI and it should boot over NFS.