RTC

Setting the RTC

To set the RTC first set the date from Linux shell, type:

$ date --set="20181231 23:59"

Then set the real time clock from Linux shell, type:

$ hwclock --systohc --utc

Power down your board wait 5 minutes and power up. Check your system with date and the time should be up to date.

Wakeup using the RTC

Wakeup using the RTC requires hardware connection of ISL12057 IRQ2# pin to a SoC GPIO (in this example GPIO1_01).
Configure your kernel and add Intersil ISL12057 driver. Device Drivers -> Real Time Clock -> <*> Intersil ISL12057.
For VAR-SOM-MX6, edit arch/arm/boot/dts/imx6qdl-var-som.dtsi
For DART-MX6, edit arch/arm/boot/dts/imx6qdl-var-dart.dtsi

rtc@0x68 {
	compatible = "isil,isl12057";
	reg = <0x68>;
	interrupt-parent = <&gpio1>;
	interrupts = <1 IRQ_TYPE_EDGE_FALLING>;
};

Follow the "Build Linux from source code" guide to build the kernel and device trees and to copy them to your SD card. Don't forget to also build and install the kernel modules.
For example, to set the RTC to wakeup after 10 seconds type:

$ rtcwake -m mem -d rtc0 -s 10

For more options, like waking up at a specific time, run:

$ rtcwake --help

IMX RTC

Contents

Setting the RTC

Wakeup using the RTC