IMX8 Android Audio
Android Audio
To give you overview we recommend you go through the https://source.android.com/devices/audio documents.
Android Provides
- Audio HAL from NXP
- Variscite adds EVK hardware support such as codec, DMIC support to the HAL.
- Once you program the images, it comes with the required HAL support to verify the Audio input / Output Functionality.
Hardware Setup
DART-MX8M
- Line IN: J21 - Audio Jack 3.5 mm
- Headphone Out: J22 - Audio Jack 3.5mm
- DMIC: On board
Audio In
- Connect 3.5 mm jack to Audio In: Ref:https://www.amazon.ca/AmazonBasics-3-5mm-Stereo-Audio-Cable/dp/B00NO73MUQ
- One end to Audio Output of the source you wish to record, one end to Audio In Jack of the DART-MX8M see above
Audio Output
- Connect 3.5 mm headphone jack to headphone / speaker
Audio In test
- Start Sound Record as per below screen shot
- If app asks for permissions click on allow for microphone and internal stroage dialoge
- Make sure you have audio line in source is playing some music
- Click on the record button and you should see below screen
Audio Out test
- To review recorded audio, you may click on play button
- Click on music player app (Cactus Player)
- Click on music / recorded audio you captured
DMIC test
To setup the DMIC use blow commands
Check current status (Default is - Line in)
Coming Soon.
To set DMIC rate 128x
Coming Soon.
To set DMIC rate 64x
Coming Soon.
To set DMIC rate 32x
Coming Soon.
To rurn-off DMIC
Coming Soon.
Use above recording application to record via the application.