VAR-SOM-MX6 Yocto GS eclipse

Programming with Eclipse and Yocto

Variscite added the required packages to the build images fsl-image-test and fsl-image-gui to enable Eclipse based Yocto development. This guide will describe how to install and use Eclipse/Yocto to develop application to run on VAR-SOM-MX6

Host tools

Build

make sure you are your build directory and environment are set correctly.

$ . ./setup-environment build_mx6q/

Build the tools:

$ bitbake meta-ide-support
$ bitbake meta-toolchain adt-installer

The result are a tools installer

$ ls tmp/deploy/sdk/

The results should be:
adt_installer.tar.bz2 poky-eglibc-x86_64-meta-toolchain-cortexa9hf-vfp-neon-toolchain-1.5.1.sh

Install

$ tmp/deploy/sdk/poky-eglibc-x86_64-meta-toolchain-cortexa9hf-vfp-neon-toolchain-1.5.1.sh

When system prompt "Enter target directory for SDK (default: /opt/poky/1.5.1):" hit enter.

When system prompt "You are about to install the SDK to "/opt/poky/1.5.1". Proceed[Y/n]?" hit Y and enter.

An install log should look like:

 tmp/deploy/sdk/poky-eglibc-x86_64-meta-toolchain-cortexa9hf-vfp-neon-toolchain-1.5.1.sh
 Enter target directory for SDK (default: /opt/poky/1.5.1):
 You are about to install the SDK to "/opt/poky/1.5.1". Proceed[Y/n]?Y<
 Extracting SDK...done
 Setting it up...done
 SDK has been successfully set up and is ready to be used.

Eclipse installation

The following steps will guide you how to download and install Eclipse Keler CDT SR1.

Download and install

Download from:

http://www.eclipse.org/downloads/download.php?file=/technology/epp/downloads/release/kepler/SR1/eclipse-cpp-kepler-SR1-linux-gtk-x86_64.tar.gz

$ cd ~/
$ tar xvf ../Downloads/eclipse-cpp-kepler-SR1-linux-gtk-x86_64.tar.gz

Run Eclipse:

$ eclipse/eclipse &

Set your workspace:

You can select any folder you like.
Close the "welcome window".
You should be at: