VAR-SOM-MX6 Yocto GS eclipse: Difference between revisions
| Line 38: | Line 38: | ||
= Eclipse installation = | = Eclipse installation = | ||
The | The following steps will guide you how to download and install Eclipse Keler CDT SR1. | ||
== Download and install == | |||
Download from: | Download from: | ||
| Line 58: | Line 58: | ||
You can select any folder you like. | You can select any folder you like. | ||
Close the " | Close the "welcome window". You should be at: | ||
== Eclipse install additional packages == | == Eclipse install additional packages == | ||
== Yocto plug-in == | == Yocto plug-in == | ||
= Create and run simple application = | = Create and run simple application = | ||
== Create application == | == Create application == | ||
Revision as of 12:10, 23 January 2014
Variscite added the required packages to the build images fsl-image-test and fsl-image-gui to enable Eclipse based Yocto development. This guide will describe how to install and use Eclipse/Yocto to develop application to run on VAR-SOM-MX6
Host tools
Build
make sure you are your build directory and environment are set correctly.
$ . ./setup-environment build_mx6q/
Build the tools:
$ bitbake meta-ide-support $ bitbake meta-toolchain adt-installer
The result are a tools installer
$ ls tmp/deploy/sdk/
The results should be:
adt_installer.tar.bz2 poky-eglibc-x86_64-meta-toolchain-cortexa9hf-vfp-neon-toolchain-1.5.1.sh
Install
tmp/deploy/sdk/poky-eglibc-x86_64-meta-toolchain-cortexa9hf-vfp-neon-toolchain-1.5.1.sh
When system prompt "Enter target directory for SDK (default: /opt/poky/1.5.1):" hit enter.
When system prompt "You are about to install the SDK to "/opt/poky/1.5.1". Proceed[Y/n]?" hit Y and enter. An install log should look like:
tmp/deploy/sdk/poky-eglibc-x86_64-meta-toolchain-cortexa9hf-vfp-neon-toolchain-1.5.1.sh Enter target directory for SDK (default: /opt/poky/1.5.1): You are about to install the SDK to "/opt/poky/1.5.1". Proceed[Y/n]?Y Extracting SDK...done Setting it up...done SDK has been successfully set up and is ready to be used.
Eclipse installation
The following steps will guide you how to download and install Eclipse Keler CDT SR1.
Download and install
Download from:
$ cd ~/ $ tar xvf ../Downloads/eclipse-cpp-kepler-SR1-linux-gtk-x86_64.tar.gz
Run Eclipse:
$ eclipse/eclipse &
Set your workspace:
Image:Eclipse ws.jpg
You can select any folder you like.
Close the "welcome window". You should be at: