Yocto Flash From Net: Difference between revisions
From Variscite Wiki
No edit summary |
No edit summary |
||
Line 40: | Line 40: | ||
Boot into U-Boot and change environment variables | Boot into U-Boot and change environment variables | ||
=> setenv serverip <your host ip address> | |||
=> setenv bootfile {{#var:KERNEL_IMAGE}} | |||
=> setenv fdt_file <relevant device tree> | |||
=> setenv nfsroot /home/<your username>/flash_rootfs | |||
=> setenv console ttymxc0 | |||
=> setenv bootcmd 'run netboot' | |||
=> saveenv | |||
=> boot | |||
On the target flash your system: | On the target flash your system: |
Revision as of 08:17, 7 June 2017
-Flash From Network Yocto system
Flashing a complete Yocto system from Network using TFTP & NFS
NOTES:
- Please make sure your host system is ready to use TFTP/NFS. Use our WIKI if required: Yocto Setup TFTP/NFS
- Mix and match the nand-recovery version with the system you would like to flash.
- This is a concept Wiki. Please adopt it to your system and your requirements.
- Android can be flashed in the same way.
Build minimal file system
$ gedit ../sources/poky/meta/recipes-core/images/core-image-minimal-mtdutils.bb
Set the image to include:
IMAGE_INSTALL += "mtd-utils imx-kobs mtd-utils-ubifs"
Build the system:
$ bitbake core-image-minimal-mtdutils
Create a root file system and copy files
$ mkdir ~/flash_rootfs $ sudo tar xvf tmp/deploy/images//core-image-minimal-mtdutils-.tar.bz2 -C ~/flash_rootfs $ sudo cp tmp/deploy/images// /tftpboot $ sudo cp tmp/deploy/images//-imx*.dtb /tftpboot/ $ sudo rename 's/-imx/imx/' /tftpboot/-*.dtb
Insert the recovery SD card into your host PC and copy the following files from it (assuming it is mounted at /media):
$ sudo cp -a /media/rootfs/opt/images ~/flash_rootfs/opt/ $ sudo cp /media/rootfs/usr/bin/*.sh ~/flash_rootfs/usr/bin
Boot into U-Boot and change environment variables
=> setenv serverip <your host ip address> => setenv bootfile => setenv fdt_file <relevant device tree> => setenv nfsroot /home/<your username>/flash_rootfs => setenv console ttymxc0
=> setenv bootcmd 'run netboot' => saveenv => boot
On the target flash your system:
$ install_yocto.sh
A complete system is flashed into the SOMs internal storage (NAND flash/eMMC). Once the file system is built you can use it again and again to flash your . You can update the images to use your images or custom install_yocto.sh to your requirements.