VAR-SOM-MX6 Start Here: Difference between revisions

From Variscite Wiki
Line 11: Line 11:
Set up your development environment.
Set up your development environment.
* [[VAR-SOM-MX6 Development Environment|Setting Development Environment]]
* [[VAR-SOM-MX6 Development Environment|Setting Development Environment]]
= Step Three: Power Up =
= Step Three: DVK Power Up =
Power up the board.
Power up the board.
</br>You should have the serial cable connected to the debug port, as describe in the quick start guide
</br>You should have the serial cable connected to the debug port, as describe in the quick start guide

Revision as of 12:34, 16 December 2015

VAR-SOM-MX6 - First Time? Start Here.

Yocto.png

Step One: Read Documentations

Please download and read the development kit documentation.

NOTE:
Make sure you read the Quick Start Guide.

Step Two: Development Environment

Set up your development environment.

Step Three: DVK Power Up

Power up the board.
You should have the serial cable connected to the debug port, as describe in the quick start guide
When board boots, make sure you see the u-boot prints on your host PC hyper terminal. You will need to type-in commands in the command prompt late in the development stages

IMPORTANT:
Don't continue without the serial console operating.

Step Four: A quick test with NAND recovery SD-Card

Please follow the below guide to boot DVK with a bootable SD-Card , and burn a complete yocto into NAND-Flash

Step Five: What next?

Your next step can be one of :