VAR-SOM-MX6 Start Here: Difference between revisions
From Variscite Wiki
Line 25: | Line 25: | ||
* Build Yocto from source code. The below steps will help you build a complete Yocto build, resulting in all required binaries to create a full bootable Yocto SD-Card, and all required binaries that are required to burn to NAND-Flash. | * Build Yocto from source code. The below steps will help you build a complete Yocto build, resulting in all required binaries to create a full bootable Yocto SD-Card, and all required binaries that are required to burn to NAND-Flash. | ||
** [[VAR-SOM-MX6 Yocto Fido R2 Build Yocto release|Build a complete Yocto]] | ** [[VAR-SOM-MX6 Yocto Fido R2 Build Yocto release|Build a complete Yocto]] | ||
** [[VAR-SOM-MX6 Yocto Fido R2 Build Linux out of tree|Build Linux Kernel from source code. | ** [[VAR-SOM-MX6 Yocto Fido R2 Build Linux out of tree|Build Linux Kernel from source code. only if changes in kernel are required (Changes in device tree..etc)]] | ||
** [[VAR-SOM-MX6 Yocto Fido R2 Build u-boot out of tree|Build u-boot from source code, only if changes in u-boot are required]] | ** [[VAR-SOM-MX6 Yocto Fido R2 Build u-boot out of tree|Build u-boot from source code, only if changes in u-boot are required]] | ||
** [[VAR-SOM-MX6 Yocto Fido R2 Customize linux-variscite |Customize linux-variscite]] | ** [[VAR-SOM-MX6 Yocto Fido R2 Customize linux-variscite |Customize linux-variscite]] |
Revision as of 12:02, 16 December 2015
VAR-SOM-MX6 - First Time? Start Here.
Step One: Read Documentations
Please download and read the development kit documentation.
NOTE:
Make sure you read the Quick Start Guide.
Make sure you read the Quick Start Guide.
Step Two: Development Environment
Set up your development environment.
Step Three: Power Up
Power up the board.
You should have the serial cable connected to the debug port, as describe in the quick start guide
When board boots, make sure you see the u-boot prints on your host PC hyper terminal. You will need to type-in commands in the command prompt late in the development stages
IMPORTANT:
Don't continue without the serial console operating.
Don't continue without the serial console operating.
Step Four: A quick test with NAND recovery SD-Card
Please follow the below guide to boot DVK with a bootable SD-Card , and burn a complete yocto into NAND-Flash
Step Five: What next?
Your next step can be one of :
- Build Yocto from source code. The below steps will help you build a complete Yocto build, resulting in all required binaries to create a full bootable Yocto SD-Card, and all required binaries that are required to burn to NAND-Flash.
- Start doing applications programming.
- Test various interfaces.
- Contact Support
- Support forum
- support@variscite.com