VAR-SOM-MX6 Start Here: Difference between revisions
From Variscite Wiki
| Line 22: | Line 22: | ||
= Step Four: NAND recovery SDCARD= | = Step Four: NAND recovery SDCARD= | ||
Create Yocto bootable SDCARD and flash it to your card. | Create Yocto bootable SDCARD and flash it to your card. | ||
* [[VAR-SOM-MX6 Yocto NAND Recovery|NAND recovery]] | * [[VAR-SOM-MX6 Yocto NAND Recovery| Create NAND recovery]] | ||
* Recover Nand Flash | |||
** Insert the SD card into the SD/MMC slot of the custom board | ** Insert the SD card into the SD/MMC slot of the custom board | ||
** Press and hold the boot-select button, power-off and power-on the board | ** Press and hold the boot-select button, power-off and power-on the board | ||
** The board will automatically boot into Linux from SD-Card | ** The board will automatically boot into Linux from SD-Card | ||
** [[VAR-SOM-MX6 Yocto NAND Recovery#Flash_from_command_line| Flash from command line]] | |||
= Step Five: = | = Step Five: = | ||
Revision as of 11:57, 15 December 2015
VAR-SOM-MX6 - First Time? Start Here
Under Construction!!!
Under Construction!!!
Under Construction!!!
Step One: Read Documentations
Please download and read the development kit documentation.
NOTE:
Make sure you read the Quick Start Guide.
Make sure you read the Quick Start Guide.
Step Two: Development Environment
Set up your development environment.
Step Three: Power Up
Power up the board.
You should have the serial cable connected.
You should also see the u-boot output on the serial.
IMPORTANT:
Don't continue without the serial console operating.
Don't continue without the serial console operating.
Step Four: NAND recovery SDCARD
Create Yocto bootable SDCARD and flash it to your card.
- Create NAND recovery
- Recover Nand Flash
- Insert the SD card into the SD/MMC slot of the custom board
- Press and hold the boot-select button, power-off and power-on the board
- The board will automatically boot into Linux from SD-Card
- Flash from command line