IMX8 Android Audio: Difference between revisions
No edit summary |
No edit summary |
||
Line 1: | Line 1: | ||
<!-- Set release according to "release" parameter in URL and use RELEASE_O8.1.0_1.3.0_8M_DART-MX8M as default | <!-- Set release according to "release" parameter in URL and use RELEASE_O8.1.0_1.3.0_8M_DART-MX8M as default | ||
--> {{INIT_RELEASE_PARAM|RELEASE_O8.1.0_1.3.0_8M_DART-MX8M}}<!-- | |||
--> {{#vardefine:RELEASE_PARAM|{{#urlget:release}}}} <!-- | --> {{#vardefine:RELEASE_PARAM|{{#urlget:release}}}} <!-- | ||
--> {{#lst:Android_Platform_Customization|{{#var:RELEASE_PARAM|RELEASE_O8.1.0_1.3.0_8M_DART-MX8M}}}} <!-- | --> {{#lst:Android_Platform_Customization|{{#var:RELEASE_PARAM|RELEASE_O8.1.0_1.3.0_8M_DART-MX8M}}}} <!-- |
Revision as of 01:08, 17 August 2023
This page is using the default release RELEASE_O8.1.0_1.3.0_8M_DART-MX8M.
To view this page for a specific Variscite SoM and software release, please follow these steps:
- Visit variwiki.com
- Select your SoM
- Select the software release
Android Audio
To give you an overview we recommend you go through the https://source.android.com/devices/audio documents.
Android Provides
- Audio HAL from NXP
- Variscite adds EVK hardware support such as codec, DMIC support to the HAL.
- Once you program the images, it comes with the required HAL support to verify the Audio input / Output Functionality.
Hardware Setup
DART-MX8M
- Line IN: J21 - Audio Jack 3.5 mm
- Headphone Out: J22 - Audio Jack 3.5mm
- DMIC: On board
Audio In
- Connect 3.5 mm jack to Audio In: Ref:https://www.amazon.ca/AmazonBasics-3-5mm-Stereo-Audio-Cable/dp/B00NO73MUQ
- One end to Audio Output of the source you wish to record, one end to Audio In Jack of the DART-MX8M see above
Audio Output
- Connect 3.5 mm headphone jack to headphone / speaker
Audio In test
- Run below commands on adb shell
# tinymix 'Headphone Volume' 35;tinymix 'Capture Input' ADC;tinymix 'DMIC Mux' DMIC2;
- Start Sound Record as per below screen shot
- If app asks for permissions click on allow for microphone and internal stroage dialoge
- Make sure you have audio line in source is playing some music
- Click on the record button and you should see below screen
Audio Out test
- To review recorded audio, you may click on the play button
- Click on the music player app (Cactus Player)
- Click on music / recorded audio you captured
DMIC test
By default, if you don't connect the audio input is selected via onboard DMIC
Use the above recording application to record via the application.