Yocto Qt6 Toolchain installation: Difference between revisions
From Variscite Wiki
(Created page with "{{Yocto_Qt_Toolchain_installation}}") |
No edit summary |
||
| Line 1: | Line 1: | ||
{{Yocto_Qt_Toolchain_installation}} | {{Yocto_Qt_Toolchain_installation}} | ||
__NUMBEREDHEADINGS__ | |||
Latest revision as of 20:44, 13 January 2023
Warning: This page is designed to be used with a 'release' URL parameter.
This page is using the default release RELEASE_MORTY_V1.0_DART-6UL.
To view this page for a specific Variscite SoM and software release, please follow these steps:
- Visit variwiki.com
- Select your SoM
- Select the software release
DART-6UL - Yocto Qt5 Toolchain Installation
Pre Requirements
Full Yocto OpenEmbedded environment is required for the toolchain generation.
To setup Yocto build environment follow steps 1 & 3 of the Build Yocto from source code guide and then proceed to the toolchain build below:
Build Toolchain
$ cd ~/var-fslc-yocto $ MACHINE=imx6ul-var-dart DISTRO=fslc-x11 . setup-environment build_x11
$ bitbake meta-toolchain-qt5
The output will be located at tmp/deploy/sdk/.
Install Toolchain
Install the tools by running it:
$ tmp/deploy/sdk/fslc-x11-glibc-x86_64-meta-toolchain-qt5-armv7at2hf-neon-toolchain-2.2.1.sh
Reply to all defaults 'y'
At the end of the installation you should see the following:
SDK has been successfully set up and is ready to be used.
The toolchain name depend on your build machine and may change
Use Toolchain
Each time you wish to use the toolchain in a new shell session, you need to source the environment setup script:
$ source /opt/fslc-x11/2.2.1/environment-setup-armv7at2hf-neon-fslc-linux-gnueabi