Yocto Build U-Boot: Difference between revisions
From Variscite Wiki
(Build U-Boot out of Yocto tree: fix "make: ./../scripts/dtb_check.sh: Command not found" when building the boot image) |
Tag: Undo |
||
| Line 84: | Line 84: | ||
$ cd imx-mkimage | $ cd imx-mkimage | ||
$ make | $ make | ||
$ cp mkimage_imx8 {{#var:IMX_MKIMAGE_SOC}}/soc.mak {{#var:IMX_MKIMAGE_SOC}}/*.sh scripts/ | $ cp mkimage_imx8 {{#var:IMX_MKIMAGE_SOC}}/soc.mak {{#var:IMX_MKIMAGE_SOC}}/*.sh scripts/pad_image.sh .. | ||
$ cd .. | $ cd .. | ||
| | | | ||
Revision as of 11:49, 24 July 2022
Yocto Build U-Boot from source code
Toolchain installation for out of Yocto builds
To install the toolchain, follow Yocto Toolchain installation.
Build U-Boot out of Yocto tree
Obtain sources:
$ git clone https://github.com/varigit/uboot-imx.git -b imx_v2015.04_4.1.15_1.1.0_ga_var03 $ cd uboot-imx
Configure compilation environment:
$ source /opt/fslc-x11/2.2.1/environment-setup-armv7at2hf-neon-fslc-linux-gnueabi
Cleanup everything:
$ make mrproper
Select one of the following configurations:
For booting from SD card/eMMC: $ make mx6var_som_sd_defconfig For booting from NAND flash: $ make mx6var_som_nand_defconfig
Build U-Boot:
$ make -j$(nproc)
Install the built U-Boot on an SD card
$ sudo dd if=SPL of=/dev/sdX bs=1K seek=1; sync $ sudo dd if=u-boot.img of=/dev/sdX bs=1K seek=69; sync (Replace /dev/sdX with the correct device)
If you want to use our recovery SD card to flash the built U-Boot to NAND flash/eMMC, then copy it to the appropriate location in the SD card:
$ sudo cp SPL /media/rootfs/opt/images/… $ sudo cp u-boot.img /media/rootfs/opt/images/…
And eject the SD card gracefully from host machine.
Note: If you manually upgrade an existing U-Boot, and you have an old environment saved, it is a good idea to reset your environment to the new default (see Environment handling commands)
Update your U-Boot out of Yocto tree
$ git pull