Yocto Setup TFTP/NFS: Difference between revisions
From Variscite Wiki
No edit summary |
No edit summary |
||
| Line 1: | Line 1: | ||
<!-- Set release according to "release" parameter in URL and use MORTY_BETA_DART-6UL as default | <!-- Set release according to "release" parameter in URL and use MORTY_BETA_DART-6UL as default --> | ||
--> {{#vardefine:RELEASE_PARAM|{{#urlget:release}}}} | {{#vardefine:RELEASE_PARAM|{{#urlget:release}}}} | ||
{{#lst:Yocto_Platform_Customization|{{#var:RELEASE_PARAM|RELEASE_MORTY_BETA_DART-6UL}}}} | |||
{{PageHeader|{{#var:HARDWARE_NAME}}- Yocto Setup TFTP/NFS}} {{DocImage|category1={{#var:HARDWARE_NAME}}|category2=Yocto}} __toc__ | |||
= Running Yocto rootfs on Variscite board using TFTP & NFS = | = Running Yocto rootfs on Variscite board using TFTP & NFS = | ||
Revision as of 13:09, 9 October 2018
- Yocto Setup TFTP/NFS
Running Yocto rootfs on Variscite board using TFTP & NFS
Host
Make sure you installed NFS server:
$ sudo apt-get install nfs-kernel-server $ cd $ sudo mkdir rootfs $ cd rootfs $ sudo tar xvf ..//tmp/deploy/images//fsl-image-gui-.tar.gz
$ sudo gedit /etc/exports
Add the following line (change <uname> to the name of user):
/rootfs *(rw,sync,no_root_squash,no_all_squash,no_subtree_check)
exit & save
$ sudo /etc/init.d/nfs-kernel-server restart
Make sure you installed TFTP server:
$ sudo apt-get install xinetd tftpd tftp
Verify:
$ ls /usr/sbin/in.tftpd
$ sudo gedit /etc/xinetd.d/tftp
service tftp
{
protocol = udp
port = 69
socket_type = dgram
wait = yes
user = nobody
server = /usr/sbin/in.tftpd
server_args = /tftpboot
disable = no
}
$ sudo mkdir /tftpboot $ sudo chmod -R 777 /tftpboot $ sudo /etc/init.d/xinetd restart $ cd // $ cp tmp/deploy/images// /tftpboot $ cp tmp/deploy/images//-imx*.dtb /tftpboot $ sudo rename 's/-//' /tftpboot/-*.dtb
Target
Make sure you have a serial connection to the target.
Reset and hold the space bar. This will bring you to U-Boot command line.
$ setenv serverip 192.168.1.188 $ setenv nfsroot /rootfs (change <uname> to the name of user) $ setenv bootcmd run netboot $ saveenv
You are all set. Connect Ethernet cable, power cycle the and it should boot over NFS.