Yocto Setup TFTP/NFS: Difference between revisions
From Variscite Wiki
No edit summary |
No edit summary |
||
| Line 53: | Line 53: | ||
{{#ifeq: {{#var:HARDWARE_NAME}} | DART-MX8M | | {{#ifeq: {{#var:HARDWARE_NAME}} | DART-MX8M | | ||
{{Note|Default kernel configuration should be modified to compile Ethernet driver into kernel image instead compiling it as a loadable module. | {{Note|Default kernel configuration should be modified to compile Ethernet driver into kernel image instead compiling it as a loadable module. | ||
Follow our kernel compilation guide {{Varlink|Yocto_Build_Linux|{{#var:RELEASE_LINK}}|Build kernel from source code}} | |||
Run "make menuconfig", go to "Device Drivers → Network device support → Ethernet driver support → Freescale devices → FEC ethernet controller" and press y. | |||
Compile the kernel and copy arch/arm64/boot/Image.gz to /tftpbbot }} | |||
}} | }} | ||
Revision as of 14:11, 9 August 2018
- Yocto Setup TFTP/NFS
Running Yocto rootfs on Variscite board using TFTP & NFS
Host
Make sure you installed NFS server:
$ sudo apt-get install nfs-kernel-server $ cd $ sudo mkdir rootfs $ cd rootfs $ sudo tar xvf ..//tmp/deploy/images//fsl-image-gui-.tar.gz
$ sudo gedit /etc/exports
Add the following line (change <uname> to the name of user):
/home/<uname>/rootfs *(rw,sync,no_root_squash,no_all_squash,no_subtree_check)
exit & save
$ sudo /etc/init.d/nfs-kernel-server restart
Make sure you installed TFTP server:
$ sudo apt-get install xinetd tftpd tftp
Verify:
$ ls /usr/sbin/in.tftpd
$ sudo gedit /etc/xinetd.d/tftp
service tftp
{
protocol = udp
port = 69
socket_type = dgram
wait = yes
user = nobody
server = /usr/sbin/in.tftpd
server_args = /tftpboot
disable = no
}
$ sudo mkdir /tftpboot $ sudo chmod -R 777 /tftpboot $ sudo /etc/init.d/xinetd restart $ cd // $ cp tmp/deploy/images// /tftpboot $ cp tmp/deploy/images//-imx*.dtb /tftpboot $ sudo rename 's/-//' /tftpboot/-*.dtb
Target
Make sure you have a serial connection to the target.
Reset and hold the space bar. This will bring you to U-Boot command line.
$ setenv serverip 192.168.1.188 $ setenv nfsroot /rootfs (change <uname> to the name of user) $ setenv bootcmd run netboot $ saveenv
You are all set. Pushing reset on the board will run your Yocto result file system.