Yocto Build U-Boot: Difference between revisions
From Variscite Wiki
No edit summary |
No edit summary |
||
Line 17: | Line 17: | ||
$ source {{#var:TOOLCHAIN_LOCATION}} | $ source {{#var:TOOLCHAIN_LOCATION}} | ||
Cleanup everything: | |||
$ make mrproper | $ make mrproper | ||
{{#ifeq: {{#var:HARDWARE_NAME}} | DART-MX8M | | {{#ifeq: {{#var:HARDWARE_NAME}} | DART-MX8M | | ||
<br> | <br> | ||
Select configuration: | |||
$ make {{#var:U-BOOT_SD_DEFCONFIG}} | $ make {{#var:U-BOOT_SD_DEFCONFIG}} | ||
Build U-Boot: | |||
$ make -j4 | |||
| | | | ||
Select one of the following configurations: | |||
For booting from SD card/eMMC: | For booting from SD card/eMMC: | ||
Line 29: | Line 35: | ||
For booting from NAND flash: | For booting from NAND flash: | ||
$ make {{#var:U-BOOT_NAND_DEFCONFIG}} | $ make {{#var:U-BOOT_NAND_DEFCONFIG}} | ||
Build U-Boot: | |||
$ make -j4 | $ make -j4 | ||
}} | |||
{{#ifeq: {{#var:HARDWARE_NAME}} | DART-MX8M | | {{#ifeq: {{#var:HARDWARE_NAME}} | DART-MX8M | |
Revision as of 09:17, 5 July 2018
Yocto Build U-Boot from source code
Toolchain installation for out of Yocto builds
To install the toolchain, follow Yocto Toolchain installation.
Build U-Boot out of Yocto tree
Obtain sources:
$ git clone https://github.com/varigit/uboot-imx.git $ cd uboot-imx $ git checkout imx_v2015.04_4.1.15_1.1.0_ga_var03
Configure compilation environment:
$ source /opt/fslc-x11/2.2.1/environment-setup-armv7at2hf-neon-fslc-linux-gnueabi
Cleanup everything:
$ make mrproper
Select one of the following configurations:
For booting from SD card/eMMC: $ make mx6var_som_sd_defconfig For booting from NAND flash: $ make mx6var_som_nand_defconfig
Build U-Boot:
$ make -j4
Install the built U-Boot on an SD card
$ sudo dd if=SPL of=/dev/sdX bs=1K seek=1; sync $ sudo dd if=u-boot.img of=/dev/sdX bs=1K seek=69; sync (Replace /dev/sdX with the correct device)
If you want to use our recovery SD card to flash the built U-Boot to NAND flash/eMMC, then copy it to the appropriate location in the SD card:
$ sudo cp SPL /media/rootfs/opt/images/... $ sudo cp u-boot.img /media/rootfs/opt/images/...
And eject the SD card gracefully from host machine.
Note: If you manually upgrade an existing U-Boot, and you have an old environment saved, it is a good idea to reset your environment to the new default (see Environment handling commands)
Update your U-Boot out of Yocto tree
$ git pull