VAR-SOM-MX6 Start Here

VAR-SOM-MX6 - First Time? Start Here.

Step One: Read Documentations

Please download and read the development kit documentation on Variscite website

NOTE:
Make sure you read the Quick Start Guide.

Step Two: Setup Linux host PC Development Environment

Set up your development environment.

• Setting Development Environment

Step Three: DVK Power Up

Power up the board.
You should have the serial cable connected to the debug port, as describe in the quick start guide
When board boots, make sure you see the U-Boot and kernel prints on your host PC terminal. You will need to type-in commands in the command prompt late in the development stages.
The Linux login is root (no password).

IMPORTANT:
Don't continue without the serial console operating.

Step Four: A quick test with a recovery SD card

Please follow the below guide to boot the DVK with a bootable SD card, and burn a complete Yocto/Android into the SOM's internal storage device/s.

• VAR-SOM-MX6 recovery SD card

Step Five: What next?

Your next step can be one of :

• Build a complete Yocto (Krogoth). This guide will help you build a complete Yocto build, resulting in all required binaries to create a full bootable Yocto SD card, and all required binaries to burn to the SOM's internal storage device/s.
  • Yocto common build errors

• Use your pre-built recovery SD card, as-is, to boot system, and start applications programming.
  • Hello World 'C' application
  • Building A QT Hello World
  • Debugging with Eclipse
  • TFTP & NFS

• Test various interfaces.
  • GPIO
  • Ethernet
  • Audio record/play
  • CAN bus
  • USB Host
  • eMMC
  • RTC
  • LVDS
  • I2C
  • Wireless LAN
  • Bluetooth
  • Backlight
  • USB OTG as host
  • USB OTG as device
  • SPI
  • External UART
• Contact Support
  • Support forum
  • support@variscite.com