DART-6UL Start Here: Difference between revisions
From Variscite Wiki
Line 51: | Line 51: | ||
* Contact Support | * Contact Support | ||
** [http://variscite.com/support-forum/index.php Support forum] | ** [http://variscite.com/support-forum/index.php Support forum] | ||
** | ** support@variscite.com |
Revision as of 14:15, 28 December 2015
DART-6UL - First Time? Start Here.
Step One: Read Documentations
Please download and read the development kit documentation. on Variscite website
NOTE:
Make sure you read the Quick Start Guide.
Make sure you read the Quick Start Guide.
Step Two: Setup Linux host PC Development Environment
Set up your development environment.
Step Three: DVK Power Up
Power up the board.
You should have the serial cable connected to the debug port, as describe in the quick start guide
When board boots, make sure you see the u-boot prints on your host PC hyper terminal. You will need to type-in commands in the command prompt late in the development stages
IMPORTANT:
Don't continue without the serial console operating.
Don't continue without the serial console operating.
Step Four: A quick test with NAND recovery SD-Card
Please follow the below guide to boot DVK with a bootable SD-Card , and burn a complete yocto into NAND-Flash
Step Five: What next?
Your next step can be one of :
- Build a complete Yocto. This guide will help you build a complete Yocto build, resulting in all required binaries to create a full bootable Yocto SD-Card, and all required binaries to burn to NAND-Flash.
- Use your pre-built rescue recovery SD-Card, as-is, to boot system, and start applications programming.
- Test various interfaces.
- Contact Support
- Support forum
- support@variscite.com