VAR-SOM-MX6 Start Here: Difference between revisions

From Variscite Wiki
Line 25: Line 25:




* Use your pre-built rescue recovery SD-Card, as-is, to boot system, and start doing applications programming.
* Use your pre-built rescue recovery SD-Card, as-is, to boot system, and start applications programming.
** [[VAR-SOM-MX6 Hello World|Hello World 'C' application]]
** [[VAR-SOM-MX6 Hello World|Hello World 'C' application]]
** [[VAR-SOM-MX6 QT Hello World|Building A QT Hello World]]
** [[VAR-SOM-MX6 QT Hello World|Building A QT Hello World]]

Revision as of 09:14, 21 December 2015

VAR-SOM-MX6 - First Time? Start Here.

Yocto.png

Step One: Read Documentations

Please download and read the development kit documentation. on Variscite website

NOTE:
Make sure you read the Quick Start Guide.

Step Two: Setup Linux host PC Development Environment

Set up your development environment.

Step Three: DVK Power Up

Power up the board.
You should have the serial cable connected to the debug port, as describe in the quick start guide
When board boots, make sure you see the u-boot prints on your host PC hyper terminal. You will need to type-in commands in the command prompt late in the development stages

IMPORTANT:
Don't continue without the serial console operating.

Step Four: A quick test with NAND recovery SD-Card

Please follow the below guide to boot DVK with a bootable SD-Card , and burn a complete yocto into NAND-Flash

Step Five: What next?

Your next step can be one of :