DART-MX8M suspend: Difference between revisions

From Variscite Wiki
No edit summary
Line 51: Line 51:


= Measuring SOM current consumption in suspend =
= Measuring SOM current consumption in suspend =
To measure SOM current consumption remove resistor R15 and connect ampere meter instead.<br>
To measure SOM current consumption remove resistor R15 on DT8MCustomBoard or R58 On Symphony board and connect ampere meter instead.<br>
It is recommended to boot from eMMC to get accurate measurement.
It is recommended to boot from eMMC to get accurate measurement.



Revision as of 09:50, 16 November 2020

DART-MX8M Suspend to RAM

Suspend to RAM

This state offers significant power savings as everything in the system is put into a low-power state, except for memory, which is placed into the self-refresh mode to retain its contents.

To suspend to RAM execute the following command:

# pm-suspend

Wake up

There are many possible ways to wake up from suspend.
A few examples:
- Pushing the ON/OFF button (when present on the board)

- Pushing a button on the board which has the boolean property "wakeup-source" set in its device tree node (under gpio_keys), e.g.:

	gpio-keys {
		compatible = "gpio-keys";
		pinctrl-names = "default";
		pinctrl-0 = <&pinctrl_gpio_keys>;
               ...
               back {
                       label = "Back";
                       gpios = <&gpio4 6 GPIO_ACTIVE_LOW>;
                       linux,code = <KEY_BACK>;
                       wakeup-source;
               };
	};

- Pressing the capacitive touch which has the "wakeup-source" property set in its device tree node, e.g.:

       ft5x06_ts: ft5x06_ts@38 {
               status = "disabled";
               compatible = "edt,edt-ft5x06";
               reg = <0x38>;
               reset-gpios = <&gpio4 5 GPIO_ACTIVE_LOW>;
               pinctrl-names = "default";
               pinctrl-0 = <&pinctrl_touch>;
               interrupt-parent = <&gpio1>;
               interrupts = <14 0>;
               touchscreen-size-x = <800>;
               touchscreen-size-y = <480>;
               touchscreen-inverted-x;
               touchscreen-inverted-y;
               wakeup-source;
       };

Measuring SOM current consumption in suspend

To measure SOM current consumption remove resistor R15 on DT8MCustomBoard or R58 On Symphony board and connect ampere meter instead.
It is recommended to boot from eMMC to get accurate measurement.