DART-MX8M suspend: Difference between revisions
No edit summary |
|||
| Line 2: | Line 2: | ||
--> {{#vardefine:RELEASE_PARAM|{{#urlget:release}}}} <!-- | --> {{#vardefine:RELEASE_PARAM|{{#urlget:release}}}} <!-- | ||
--> {{#lst:Yocto_Platform_Customization|{{#var:RELEASE_PARAM|RELEASE_SUMO_V1.0_DART-MX8M}}}} <!-- | --> {{#lst:Yocto_Platform_Customization|{{#var:RELEASE_PARAM|RELEASE_SUMO_V1.0_DART-MX8M}}}} <!-- | ||
--> {{PageHeader|{{#var:HARDWARE_NAME}} Suspend to RAM}}{{DocImage|category1=Yocto|category2=DART-MX8M}}[[Category:DART-MX8M-MINI]] | --> {{PageHeader|{{#var:HARDWARE_NAME}} Suspend to RAM}}{{DocImage|category1=Yocto|category2=DART-MX8M}}[[Category:DART-MX8M-MINI]][[Category:Debian]] | ||
= Suspend to RAM = | = Suspend to RAM = | ||
Revision as of 05:14, 17 July 2020
Suspend to RAM
This state offers significant power savings as everything in the system is put into a low-power state, except for memory, which is placed into the self-refresh mode to retain its contents.
To suspend to RAM execute the following command:
# pm-suspend
Wake up
There are many possible ways to wake up from suspend.
A few examples:
- Pushing the ON/OFF button (when present on the board)
- Pushing a button on the board which has the boolean property "wakeup-source" set in its device tree node (under gpio_keys), e.g.:
gpio-keys {
compatible = "gpio-keys";
pinctrl-names = "default";
pinctrl-0 = <&pinctrl_gpio_keys>;
...
back {
label = "Back";
gpios = <&gpio4 6 GPIO_ACTIVE_LOW>;
linux,code = <KEY_BACK>;
wakeup-source;
};
};
- Pressing the capacitive touch which has the "wakeup-source" property set in its device tree node, e.g.:
ft5x06_ts: ft5x06_ts@38 {
status = "disabled";
compatible = "edt,edt-ft5x06";
reg = <0x38>;
reset-gpios = <&gpio4 5 GPIO_ACTIVE_LOW>;
pinctrl-names = "default";
pinctrl-0 = <&pinctrl_touch>;
interrupt-parent = <&gpio1>;
interrupts = <14 0>;
touchscreen-size-x = <800>;
touchscreen-size-y = <480>;
touchscreen-inverted-x;
touchscreen-inverted-y;
wakeup-source;
};
Measuring SOM current consumption in suspend
To measure SOM current consumption remove resistor R15 and connect ampere meter instead.
It is recommended to boot from eMMC to get accurate measurement.