DART-6UL Start Here: Difference between revisions
From Variscite Wiki
No edit summary |
|||
| (4 intermediate revisions by 3 users not shown) | |||
| Line 10: | Line 10: | ||
= Step Three: DVK Power Up = | = Step Three: DVK Power Up = | ||
Power up the board. | Power up the board.<br> | ||
< | You should have the serial cable connected to the debug port, as describe in the quick start guide<br> | ||
< | When board boots, make sure you see the U-Boot and kernel prints on your host PC terminal. You will need to type-in commands in the command prompt late in the development stages.<br> | ||
The Linux login is root (no password). | |||
{{note| IMPORTANT:<br>Don't continue without the serial console operating.|info}} | {{note| IMPORTANT:<br>Don't continue without the serial console operating.|info}} | ||
| Line 21: | Line 22: | ||
= Step Five: What next?= | = Step Five: What next?= | ||
Your next step can be one of : | Your next step can be one of : | ||
* [[DART-6UL Yocto | * [[DART-6UL Yocto Krogoth R1 build|Build a complete Yocto]]. This guide will help you build a complete Yocto build, resulting in all required binaries to create a full bootable Yocto SD-Card, and all required binaries to burn to NAND-Flash. | ||
** [[VAR-SOM-MX6_Yocto Common Errors|Yocto common build errors</span>]] | ** [[VAR-SOM-MX6_Yocto Common Errors|Yocto common build errors</span>]] | ||
| Line 50: | Line 51: | ||
** [[DART-6UL UART|External UART]] | ** [[DART-6UL UART|External UART]] | ||
* Contact Support | * Contact Support | ||
** support@variscite.com | ** support@variscite.com | ||
Latest revision as of 16:42, 8 November 2022
DART-6UL - First Time? Start Here.
Step One: Read Documentations
Please download and read the development kit documentation. on Variscite website
NOTE:
Make sure you read the Quick Start Guide.
Make sure you read the Quick Start Guide.
Step Two: Setup Linux host PC Development Environment
Set up your development environment.
Step Three: DVK Power Up
Power up the board.
You should have the serial cable connected to the debug port, as describe in the quick start guide
When board boots, make sure you see the U-Boot and kernel prints on your host PC terminal. You will need to type-in commands in the command prompt late in the development stages.
The Linux login is root (no password).
IMPORTANT:
Don't continue without the serial console operating.
Don't continue without the serial console operating.
Step Four: A quick test with NAND recovery SD-Card
Please follow the below guide to boot DVK with a bootable SD-Card , and burn a complete yocto into NAND-Flash
Step Five: What next?
Your next step can be one of :
- Build a complete Yocto. This guide will help you build a complete Yocto build, resulting in all required binaries to create a full bootable Yocto SD-Card, and all required binaries to burn to NAND-Flash.
- Use your pre-built rescue recovery SD-Card, as-is, to boot system, and start applications programming.
- Test various interfaces.
- Contact Support
- support@variscite.com