VAR-SOM-AM43 GBIT Ethernet: Difference between revisions
From Variscite Wiki
No edit summary |
|||
| (11 intermediate revisions by one other user not shown) | |||
| Line 1: | Line 1: | ||
{{PageHeader|VAR-SOM-AM43 - On Carrier Gbit Ethernet ETH1}} {{DocImage|category1=VAR-SOM-AM43|category2=Yocto}} __toc__ | |||
This Second ethenet interface (phy on carrier board) is available only if the VAR-SOM-AM43 SOM without a WiFi module.<br> | |||
In Uboot an autodetect mechanism will detect the type of module used and select the proper .dtb accordingly.<br> | |||
For a module with WiFi 'var-som-am43.dtb' is selected, for a module without WiFi 'var-som-am43-eth1.dtb' is selected.<br> | |||
Please follow the instructions below to activate the ETH1 device and acquire IP for testing.<br> | |||
< | |||
On Target: | On Target: | ||
<pre> | <pre> | ||
Latest revision as of 09:22, 28 December 2015
VAR-SOM-AM43 - On Carrier Gbit Ethernet ETH1
This Second ethenet interface (phy on carrier board) is available only if the VAR-SOM-AM43 SOM without a WiFi module.
In Uboot an autodetect mechanism will detect the type of module used and select the proper .dtb accordingly.
For a module with WiFi 'var-som-am43.dtb' is selected, for a module without WiFi 'var-som-am43-eth1.dtb' is selected.
Please follow the instructions below to activate the ETH1 device and acquire IP for testing.
On Target:
$ ifconfig eth0 down $ ifconfig eth1 up $ udhcpc -i eth1 $ ifconfig $ iperf -s -u
On Host:
$ iperf -c 192.168.1.82 -u -b450M