Yocto Toolchain installation: Difference between revisions

Revision as of 09:17, 28 June 2017

Yocto toolchain installation for out of Yocto builds

Pre Requirements

Full Yocto OpenEmbedded environment is required for the toolchain generation.
To setup Yocto build environment follow steps 1 & 3 of the Build Yocto from source code guide and then proceed to the toolchain build below:

Build Toolchain

$ cd ~/var-fslc-yocto
$ MACHINE=imx6ul-var-dart DISTRO=fslc-x11  build_x11
$ bitbake meta-ide-support
$ bitbake meta-toolchain

The output will be located at tmp/deploy/sdk/.

Install Toolchain

Install the tools by running it:

$ tmp/deploy/sdk/fslc-x11-glibc-x86_64-meta-toolchain-armv7at2hf-neon-toolchain-2.2.1.sh

Reply to all defaults 'y'
At the end of the installation you should see the following:

SDK has been successfully set up and is ready to be used.

The toolchain name depend on your build machine and may change

Use Toolchain

Each time you wish to use the toolchain in a new shell session, you need to source the environment setup script:

$ source /opt/fslc-x11/2.2.1/environment-setup-armv7at2hf-neon-fslc-linux-gnueabi

@@ Line 1: / Line 1: @@
-<!-- Set release according to "release" parameter in URL and use MORTY_BETA_DART-6UL as default
+<!-- Set release according to "release" parameter in URL and use RELEASE_MORTY_V1.0_DART-6UL as default
 --> {{#vardefine:RELEASE_PARAM|{{#urlget:release}}}} <!--
---> {{#lst:Yocto_Platform_Customization|{{#var:RELEASE_PARAM|RELEASE_MORTY_BETA_DART-6UL}}}} <!--
+--> {{#lst:Yocto_Platform_Customization|{{#var:RELEASE_PARAM|RELEASE_MORTY_V1.0_DART-6UL}}}} <!--
 --> {{PageHeader|Yocto toolchain installation for out of Yocto builds}} {{DocImage|category1=Yocto|category2={{#var:HARDWARE_NAME}}}} __toc__