VAR-SOM-AM43 GBIT Ethernet: Difference between revisions
From Variscite Wiki
| Line 1: | Line 1: | ||
= On Carrier Gbit Ethernet - ETH1 = | = On Carrier Gbit Ethernet - ETH1 = | ||
First, make sure your VAR-SOM-AM43 device supports ETH1. | First, make sure your VAR-SOM-AM43 device supports ETH1. | ||
Please follow the instructions below:<br> | Please follow the instructions below:<br> | ||
1) Build the correct DTB that supports ETH1 port and replace it on the SD-Card:<br> | 1) Build the correct DTB that supports ETH1 port and replace it on the SD-Card:<br> | ||
Revision as of 16:46, 23 December 2015
On Carrier Gbit Ethernet - ETH1
First, make sure your VAR-SOM-AM43 device supports ETH1.
Please follow the instructions below:
1) Build the correct DTB that supports ETH1 port and replace it on the SD-Card:
make -j6 ARCH=arm CROSS_COMPILE=arm-linux-gnueabihf- var-som-am43-eth1.dtb sudo cp arch/arm/boot/dts/var-som-am43-eth1.dtb /media/rootfs/boot/var-som-am43.dtb sync sudo umount /media/boot/ sudo umount /media/rootfs sudo umount /media/user
2) Then, activate the ETH1 device and acquire IP for testing. On Target:
$ ifconfig eth0 down $ ifconfig eth1 up $ udhcpc -i eth1 $ ifconfig $ iperf -s -u
On Host:
$ iperf -c 192.168.1.82 -u -b450M