DART-MX8M RTC: Difference between revisions
From Variscite Wiki
No edit summary |
(Add Debian_Platform_Customization) |
||
| Line 3: | Line 3: | ||
--> {{#lst:Yocto_Platform_Customization|{{#var:RELEASE_PARAM}}}} <!-- | --> {{#lst:Yocto_Platform_Customization|{{#var:RELEASE_PARAM}}}} <!-- | ||
--> {{#lst:B2QT_Platform_Customization|{{#var:RELEASE_PARAM}}}} <!-- | --> {{#lst:B2QT_Platform_Customization|{{#var:RELEASE_PARAM}}}} <!-- | ||
--> {{#lst:Debian_Platform_Customization|{{#var:RELEASE_PARAM}}}} <!-- | |||
--> {{PageHeader|{{#var:HARDWARE_NAME}} - Real Time Clock (RTC)}} {{DocImage|category1=Yocto|category2=Debian}}[[Category:DART-MX8M]][[Category:DART-MX8M-MINI]][[Category:DART-MX8M-PLUS]] __toc__ | --> {{PageHeader|{{#var:HARDWARE_NAME}} - Real Time Clock (RTC)}} {{DocImage|category1=Yocto|category2=Debian}}[[Category:DART-MX8M]][[Category:DART-MX8M-MINI]][[Category:DART-MX8M-PLUS]] __toc__ | ||
= Setting the RTC = | = Setting the RTC = | ||
Revision as of 17:17, 7 February 2023
DART-MX8M - Real Time Clock (RTC)
Setting the RTC
First set the system date & time:
# date --set="20171231 23:59"
Then set the HW RTC using the system date & time:
# hwclock --systohc --utc
Power down your board, wait 5 minutes and power up again, then check you system date & time and verify it is correct:
# date
Wake-up using the RTC
Wake-up using the RTC requires hardware connection of RTC IRQ pin to a SoC GPIO.
On DART-MX8M, DART-MX8M-MINI and DART-MX8M-PLUS carrier boards RTC IRQ pin is connected to GPIO1_15.
On VAR-SOM-MX8M-MINI, VAR-SOM-MX8M-NANO VAR-SOM-MX8M-PLUS carrier boards RTC IRQ pin is not connected.
Using rtcwake command
For example, to set the RTC to wakeup after 10 seconds type:
# echo enabled > /sys/class/rtc/rtc0/device/power/wakeup # rtcwake -m mem -d rtc0 -s 10
For more options, like waking up at a specific time, run:
# rtcwake --help