YPC VAR-SOM-MX8

mx8-yocto-hardknott-5.10.72_2.2.1-v1.1

-->

--> |- | Release 1.1 || |- | U-Boot: fec2: aligned to fec1 for consistency || |- | U-Boot: fec1: tune phy-reset-post-delay with proper value || |- | U-Boot: ethphy1: remove no need rx-internal-delay-ps property || |- | Linux: ethphy1: remove no need rx-internal-delay-ps property || |- | Linux: ptn5150: use interrupts instead of deprecated int-gpio || |- | Linux: extcon: ptn5150: Add irq-is-id-quirk || |- | Linux: imx-lpi2c: change log level for eDMA related logs || |- | Linux: ptn5150: enable irq-is-id-quirk || irq-is-id-quirk allows the id pin to be used as an interrupt to avoid using a separate device tree file for Symphony <= 1.4. |- | meta-layer: libubootenv: link with bfd instead of gold || |- | meta-layer: linux-variscite: Remove KERNEL_CONFIG_COMMAND || |- | Release 1.0 || |- | Initial Yocto Hardknott release based on NXP lf-5.10.72_2.2.1 || (kernel 5.10.72) |- ! Known Issues !! |- | RPMSG Demos from U-Boot || Starting from BSP 5.10.72 NXP stopped supporting Cortex-m firmwares loaded from U-Boot |- | HDMI and DP suspend/resume crash || Using HDMI or DP display, resume from suspend ends up in a kernel crash |- | USB Type-A ports are not supported in U-Boot on SPEAR-MX8 || U-Boot USB driver does not recognize USB devices behind the hub |- | USB Type-A ports don't work after resume from suspend in Linux on SPEAR-MX8 || USB driver does not recognize USB devices behind the hub |}