Yocto Flash From Net

- Flash Yocto images from network

Flashing a complete Yocto system from Network using TFTP & NFS

NOTES:

1. Please make sure your host system is ready to use TFTP/NFS. Use our Wiki if required: Yocto Setup TFTP/NFS
2. This is a concept Wiki. Please adopt it to your system and your requirements.
3. Android can be flashed in the same way.

Build minimal file system

$ gedit ../sources/poky/meta/recipes-core/images/core-image-minimal-mtdutils.bb

Set the image to include: IMAGE_INSTALL += "mtd-utils imx-kobs mtd-utils-ubifs"
Build the system:

$ bitbake core-image-minimal-mtdutils

Create a root file system and copy files: $ mkdir ~/flash_rootfs

$ sudo tar xvf tmp/deploy/images//core-image-minimal-mtdutils-.tar.bz2 -C ~/flash_rootfs
$ sudo cp tmp/deploy/images// /tftpboot
$ for f in tmp/deploy/images//*.dtb; do if [[ -L $f ]] && [[ $f != *.dtb ]]; then sudo cp $f /tftpboot/; fi done
$ sudo rename 's/-imx/imx/' /tftpboot/-*.dtb

Insert the recovery SD card into your host PC and copy the following files from it (assuming it is mounted at /media):

$ sudo cp -a /media/rootfs/opt/images ~/flash_rootfs/opt/
$ sudo cp /media/rootfs/usr/bin/*.sh ~/flash_rootfs/usr/bin

Boot the board, stop the autoboot to get to the U-Boot command line, and set the following environment variables:

=> setenv serverip <your host ip address>
=> setenv nfsroot /home/<your username>/flash_rootfs

If you want to set the fdt file yourself, instead of using the default auto detection:
=> setenv fdt_file <relevant device tree>

=> setenv bootcmd 'run netboot'
=> saveenv
=> boot

On the target flash your system:

# install_yocto.sh

A complete system is flashed into the SOMs internal storage (NAND flash/eMMC).
Once the file system is built you can use it again and again to flash your .
You can update the images to use your images and/or customize install_yocto.sh to your requirements.