Yocto Qt5 Toolchain installation: Difference between revisions
From Variscite Wiki
| Line 11: | Line 11: | ||
$ cd {{#var:BUILD_FOLDER}} | $ cd {{#var:BUILD_FOLDER}} | ||
$ MACHINE={{#var:MACHINE_NAME}} DISTRO={{#var:BUILD_DISTRO}} {{#var:BUILD_SCRIPT}} {{#var:BUILD_FOLDER_X11}} | $ MACHINE={{#var:MACHINE_NAME}} DISTRO={{#var:BUILD_DISTRO}} {{#var:BUILD_SCRIPT}} {{#ifeq: {{#var:HARDWARE_NAME}}|DART-MX8M|-b|}} {{#var:BUILD_FOLDER_X11}} | ||
$ bitbake meta-toolchain-qt5 | $ bitbake meta-toolchain-qt5 | ||
Revision as of 14:22, 19 December 2018
- Yocto QT5 Toolchain Installation
Pre Requirements
Full Yocto OpenEmbedded environment is required for the toolchain generation.
To setup Yocto build environment follow steps 1 & 3 of the Build Yocto from source code guide and then proceed to the toolchain build below:
Build Toolchain
$ cd $ MACHINE= DISTRO= $ bitbake meta-toolchain-qt5
The output will be located at tmp/deploy/sdk/.
Install Toolchain
Install the tools by running it:
$ tmp/deploy/sdk/
Reply to all defaults 'y'
At the end of the installation you should see the following:
SDK has been successfully set up and is ready to be used.
The toolchain name depend on your build machine and may change
Use Toolchain
Each time you wish to use the toolchain in a new shell session, you need to source the environment setup script:
$ source