Yocto Build U-Boot: Difference between revisions

From Variscite Wiki
No edit summary
(If SOC_FAMILY = imx8m and IMX_MKIMAGE_SOC_PATCH is defined, patch instead of copy soc.mak)
Line 101: Line 101:
  {{#ifeq: {{#var:SOC_FAMILY}}|imx8m|
  {{#ifeq: {{#var:SOC_FAMILY}}|imx8m|
  $ git clone {{#var:META_VARISCITE_GIT}} -b {{#var:META_VARISCITE_BRANCH}}
  $ git clone {{#var:META_VARISCITE_GIT}} -b {{#var:META_VARISCITE_BRANCH}}
  {{#ifeq: {{#var:FSL_BSP_VERSION}}|L4.14.78-1.0.0_ga||$ cp meta-variscite-imx/recipes-bsp/imx-mkimage/files/soc.mak .}}
  {{#ifeq: {{#var:FSL_BSP_VERSION}}|L4.14.78-1.0.0_ga||
{{#if: {{#var:IMX_MKIMAGE_SOC_PATCH}}|
$ cd imx-mkimage
$ git apply ../meta-variscite-imx/{{#var:IMX_MKIMAGE_SOC_PATCH}}
$ cp iMX8M/soc.mak ..
$ cd ..
|
$ cp meta-variscite-imx/recipes-bsp/imx-mkimage/files/soc.mak . }}
}}
  |
  |
  }}
  }}

Revision as of 16:59, 3 September 2020

Yocto Build U-Boot from source code

Toolchain installation for out of Yocto builds

To install the toolchain, follow Yocto Toolchain installation.

Build U-Boot out of Yocto tree

Obtain sources:

$ git clone https://github.com/varigit/uboot-imx.git -b imx_v2015.04_4.1.15_1.1.0_ga_var03
$ cd uboot-imx

Configure compilation environment:

$ source /opt/fslc-x11/2.2.1/environment-setup-armv7at2hf-neon-fslc-linux-gnueabi

Cleanup everything:

$ make mrproper

Select one of the following configurations:

For booting from SD card/eMMC:
$ make mx6var_som_sd_defconfig

For booting from NAND flash:
$ make mx6var_som_nand_defconfig

Build U-Boot:

$ make -j4


Install the built U-Boot on an SD card


$ sudo dd if=SPL of=/dev/sdX bs=1K seek=1; sync
$ sudo dd if=u-boot.img of=/dev/sdX bs=1K seek=69; sync
(Replace /dev/sdX with the correct device)

If you want to use our recovery SD card to flash the built U-Boot to NAND flash/eMMC, then copy it to the appropriate location in the SD card:

$ sudo cp SPL /media/rootfs/opt/images/... 
$ sudo cp u-boot.img /media/rootfs/opt/images/...

And eject the SD card gracefully from host machine.


Note: If you manually upgrade an existing U-Boot, and you have an old environment saved, it is a good idea to reset your environment to the new default (see Environment handling commands)

Update your U-Boot out of Yocto tree

$ git pull