VAR-SOM-AM43 Start Here Fido: Difference between revisions

From Variscite Wiki
(Created page with "{{PageHeader|VAR-SOM-AM43 - First Time? Start Here.}} {{DocImage|category1=VAR-SOM-AM43|category2=Yocto}} __toc__ x300px = Step One: Read Documentations = P...")
 
m (Text replacement - "http://variscite" to "https://variscite")
Line 27: Line 27:


* Use your pre-built rescue recovery SD-Card, as-is, to boot system, and start applications programming. email support@variscite.com for FTP credentials.
* Use your pre-built rescue recovery SD-Card, as-is, to boot system, and start applications programming. email support@variscite.com for FTP credentials.
**[http://variscite.com/support-forum/viewtopic.php?f=9&t=27 Compiling QT5 application]
**[https://variscite.com/support-forum/viewtopic.php?f=9&t=27 Compiling QT5 application]
**[[VAR-SOM-AM33 Linux SDK 7 Basic debug with Eclipse| Application debugging with Eclipse]]
**[[VAR-SOM-AM33 Linux SDK 7 Basic debug with Eclipse| Application debugging with Eclipse]]


Line 34: Line 34:


* Contact Support
* Contact Support
** [http://variscite.com/support-forum/index.php Support forum]
** [https://variscite.com/support-forum/index.php Support forum]
** support@variscite.com
** support@variscite.com

Revision as of 11:56, 10 June 2020

VAR-SOM-AM43 - First Time? Start Here.

Yocto.png

Step One: Read Documentations

Please download and read the development kit documentation. on Variscite website:
http://www.variscite.com/products/system-on-module-som/cortex-a9/var-som-am43-cpu-ti-am437x-am4376-am4377-am4378-am4379

NOTE:
Make sure you read the Quick Start Guide.

Step Two: Setup Linux host PC Development Environment

Set up your development environment.

Step Three: DVK Power Up

Power up the board.
You should have the serial cable connected to the debug port, as describe in the quick start guide
When board boots, make sure you see the u-boot prints on your host PC hyper terminal. You will need to type-in commands in the command prompt late in the development stages

IMPORTANT:
Don't continue without the serial console operating.

Step Four: A quick test with NAND recovery SD-Card

Please follow the below guide to boot DVK with a bootable SD-Card , and burn a complete yocto into NAND-Flash

Step Five: What next?

Your next step can be one of :



  • Test various interfaces : go to 'How to' section in main page.