IMX RTC

From Variscite Wiki
DART-MX8M - Real Time Clock (RTC)

1 Setting the RTC

Please note that starting from kernel 5.x the RTC node in the device tree must not include the IRQ pin declaration if it is not actually connected.
If a wrong declaration is present the hwclock command will fail.

First set the system date & time:

# date --set="20171231 23:59"

Then set the HW RTC using the system date & time:

# hwclock --systohc --utc

Power down your board, wait 5 minutes and power up again, then check you system date & time and verify it is correct:

# date

2 Wakeup using the RTC

All Variscite EVKs mount RTC ISL12057, however wakeup using the RTC requires hardware connection of ISL12057 IRQ2# pin to a SoC GPIO.
By default, the defconfig of latest kernels already enable the Intersil ISL12057 driver.
The kernel configuration item is available in Device Drivers -> Real Time Clock -> <*> Intersil ISL12057.


For DART-MX8M on DT8MCustomBoard, RTC IRQ#2 pin is already connected to pin J3.38 of the SoM.

2.1 Using rtcwake command

Assuming the your board implement RTC wakeup capabilities, ensure RTC and system time are synchronized

# hwclock -w

then set the RTC to wakeup after 10 seconds type:

# echo enabled > /sys/class/rtc/rtc0/device/power/wakeup
# echo `date "+%s" -d "+ 10 seconds"` > /sys/class/rtc/rtc0/wakealarm

and immediately suspend the machine

# pm-suspend