Linux CAN bus: Difference between revisions

From Variscite Wiki
No edit summary
No edit summary
Line 2: Line 2:
{{DocImage|category1=Yocto|category2=VAR-SOM-MX6}}[[Category:DART-6UL]] [[Category:VAR-SOM-MX7]] [[Category:DART-MX8M]] [[Category:DART-MX8M-MINI]] [[Category:VAR-SOM-MX8X]] [[Category:VAR-SOM-MX8]]
{{DocImage|category1=Yocto|category2=VAR-SOM-MX6}}[[Category:DART-6UL]] [[Category:VAR-SOM-MX7]] [[Category:DART-MX8M]] [[Category:DART-MX8M-MINI]] [[Category:VAR-SOM-MX8X]] [[Category:VAR-SOM-MX8]]


Connect 2 boards with the appropriate cable.<br>
Connect two boards like the following:<br>
<u>Board A</u>  <u>Board B</u>
  CAN_H --- CAN_H
  CAN_L --- CAN_L
  GND ----- GND


Set up the boards by running the following on each of them:<br>  
Set up the boards by running the following on each of them:<br>  
<pre>
# ip link set can0 up type can bitrate 125000
$ ip link set can0 up type can bitrate 125000
</pre>


Then:<br>
Then:<br>
On board #1:<br>  
On board A:<br>  
<pre>
# candump can0
$ candump can0
</pre>


On board #2:<br>  
On board B:<br>  
<pre>
# cansend can0 500#1E.10.10
$ cansend can0 500#1E.10.10
</pre>

Revision as of 12:52, 29 December 2019

CAN bus

Connect two boards like the following:

Board A   Board B

 CAN_H --- CAN_H
 CAN_L --- CAN_L
  GND ----- GND

Set up the boards by running the following on each of them:

# ip link set can0 up type can bitrate 125000

Then:
On board A:

# candump can0

On board B:

# cansend can0 500#1E.10.10