DART-MX8M suspend: Difference between revisions

From Variscite Wiki
No edit summary
No edit summary
Line 16: Line 16:
A few examples:<br>
A few examples:<br>
- Pushing the ON/OFF button (when present on the board)<br>
- Pushing the ON/OFF button (when present on the board)<br>
{{#ifeq: {{#var:HARDWARE_NAME}}|VAR-SOM-MX8M_NANO|{{note|Note: VAR-SOM-MX8M-NANO carrier board has no ON/OFF button. Short circuit J3.4 and J3.6 for a very short time to simulate it|info}}|}}
{{#ifeq: {{#var:HARDWARE_NAME}}|VAR-SOM-MX8M-NANO|{{note|Note: VAR-SOM-MX8M-NANO carrier board has no ON/OFF button. Short circuit J3.4 and J3.6 for a very short time to simulate it|info}}|}}
- Pushing a button on the board which has the boolean property "wakeup-source" set in its device tree node (under gpio_keys), e.g.:
- Pushing a button on the board which has the boolean property "wakeup-source" set in its device tree node (under gpio_keys), e.g.:



Revision as of 14:01, 28 January 2020

DART-MX8M Suspend to RAM

Suspend to RAM

This state offers significant power savings as everything in the system is put into a low-power state, except for memory, which is placed into the self-refresh mode to retain its contents.

To suspend to RAM execute the following command:

# pm-suspend

Wake up

There are many possible ways to wake up from suspend.
A few examples:
- Pushing the ON/OFF button (when present on the board)

- Pushing a button on the board which has the boolean property "wakeup-source" set in its device tree node (under gpio_keys), e.g.:

	gpio-keys {
		compatible = "gpio-keys";
		pinctrl-names = "default";
		pinctrl-0 = <&pinctrl_gpio_keys>;
               ...
               back {
                       label = "Back";
                       gpios = <&gpio4 6 GPIO_ACTIVE_LOW>;
                       linux,code = <KEY_BACK>;
                       wakeup-source;
               };
	};

- Pressing the capacitive touch which has the "wakeup-source" property set in its device tree node, e.g.:

       ft5x06_ts: ft5x06_ts@38 {
               status = "disabled";
               compatible = "edt,edt-ft5x06";
               reg = <0x38>;
               reset-gpios = <&gpio4 5 GPIO_ACTIVE_LOW>;
               pinctrl-names = "default";
               pinctrl-0 = <&pinctrl_touch>;
               interrupt-parent = <&gpio1>;
               interrupts = <14 0>;
               touchscreen-size-x = <800>;
               touchscreen-size-y = <480>;
               touchscreen-inverted-x;
               touchscreen-inverted-y;
               wakeup-source;
       };

Measuring SOM current consumption in suspend

To measure SOM current consumption remove resistor R15 and connect ampere meter instead.
It is recommended to boot from eMMC to get accurate measurement.